We start by pumping out any standing water, then move straight into liner installation and humidity control.
A rushed encapsulation job with unsealed seams or unwrapped piers looks fine on day one and fails within a season. We treat seam sealing and pier wrapping as core parts of the install, not optional add-ons that get skipped to save time.
Every crew member is trained specifically on liner installation, seam sealing, and vent encapsulation, not general basement work.
Mount Sterling, KY crawl space calls get scheduled fast, especially when there's standing water or an active mold smell involved.
No hourly billing — the number we quote is the number on the final invoice.
We measure relative humidity before and after installation to confirm the space is actually staying below the threshold where mold and wood rot take hold.
Every Mount Sterling, KY Crawl Space Encapsulation job starts with an inspection, not a generic package — here's what that typically includes.
Extraction equipment includes submersible pumps sized for tight crawl space access points.
We install heavy-duty liner rated for crawl space conditions, sealed at every seam and pier to stop ground moisture from reaching the floor joists.
Sealed vents are paired with mechanical dehumidification so the space doesn't just trap humidity instead of venting it.
A crawl space needs its own sump basin and discharge line separate from any basement system, since the two spaces drain differently.
We also check subfloor insulation for water damage and replace anything compromised before closing the liner.
We ask about standing water, musty odor, and vent condition to gauge scope before scheduling the inspection.
We take humidity and moisture readings to establish a baseline before recommending a system.
You'll see square footage, liner grade, vent sealing, and dehumidifier specs broken out in the written estimate.
Most residential encapsulations finish in one to two days depending on square footage and access.
"Our crawl space had standing water and a mold smell we couldn't get rid of no matter what we tried. Full encapsulation with a dehumidifier fixed it in one visit."
— Mount Sterling Homeowner
"Sump discharge from the old system was dumping water right back next to the foundation. They rerouted it and the crawl space finally dried out."
— Mount Sterling Customer
"Access to our crawl space is tight and awkward, but the crew didn't seem bothered by it at all."
— Mount Sterling Homeowner
"Musty smell in our upstairs hallway is completely gone now that the crawl space is sealed."
— Mount Sterling Customer
We can scope either option depending on your budget and how severe the existing moisture problem is.
Most residential spaces do well with a 12-15 mil liner; spaces used for storage or with foot traffic often need 20 mil for durability.
Some jurisdictions have code requirements around vent sealing, which we'll flag during the inspection if relevant.
If the smell persists after encapsulation, that usually points to a separate moisture source we'd need to investigate.
Yes — we extract existing water first, then proceed with liner and vent sealing once the space is dry enough to work safely.
Most residential jobs finish in one to two days depending on square footage and how much prep work is needed.
We encapsulate crawl spaces throughout Mount Sterling and the surrounding Mount Sterling, KY service area, including the zip codes listed below.
Zip codes we serve in Mount Sterling, KY: 40353
Call now for a free inspection and a flat-rate quote before anything gets worse.
Call +1-866-476-1348© SGP Waterproofing. All rights reserved.
